Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Profile for C172
09-19-2017, 07:18 AM (This post was last modified: 09-19-2017 07:50 AM by iwik.)
Post: #1
Profile for C172
Hi guys,
Can someone provide me with the above profile for Fsforce. I dont think my Dragonfly yoke is performing properly. I would have thought selecting the Light GA profile and then
selecting the Complex vibs for Ground ops i would have something that gave me
engine vibrations when throttling up on the ground .
Also when i trim for level flight i would have expected pushing the yoke forward at say 100knots would have produced a force and like wise when pulling back. But i get a mushy band
where there is no force. thats why i am asking if someone has a yoke setup for a C172
to see what i get. I have another FFB yoke which performs much like i would expect.
I am not a real pilot so cant be sure what i am getting is correct.
Please help.
Thanks
Regards
les
Find all posts by this user
Quote this message in a reply
11-02-2017, 09:29 AM (This post was last modified: 11-06-2017 10:30 AM by RMM.)
Post: #2
RE: Profile for C172
Hello Les..
I have the earlier Kickstarter model that was sent to a few backers before the final Dragonfly update was provided to the bulk of the Kickstarter backers.

I am keenly interested in discussing how to set the profile in FSForce2 software from Russ Dirks. I fly exclusively P3d v3.4 with the A2A C172. I don't use FSUICPC.

New firmware and some careful time setting up the FSForce profile for the A2A Cessna has given me a reasonable result. But still feel there are some unrealistic aspects.

If you would like to engage on this outside the forum, please send me a PM.

RMM
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)